Reverb won't record

[oossyy]

I been trying to print a song in pro tools by using a print track. Everything records fine on the print track, except for the reverb on the vocals. I have inserted the reverb on a vocal bus as you can see on the picture. Any tips on why the reverb is not recording on the print track??

[BScout]

Easy.
Because you are sending your Reverb channel's output to your monitor track and not your print bus. You've done the same with your Delay track (if you were using it.)

Frankly, looking at your routing, I don't know why you are sending your submix via a Send to your print bus. It should be sent through the output of the submix track to your print bus.

Right now you are double monitoring your signal: once from the Submix track and once from the Print Bus track. Another mistake.

[JFreak]

Yea, the submix buss is totally unnecessary. Just use the print (audio) track for printing and monitoring. Just remember to have either track record armed or input monitoring enabled, otherwise you are always monitoring the printed audio track.