Mirroring an Output Pair to the AES (Encl) Outs

[Bentstring]

Hey! So... when you first install HD Digital interfaces, in the Main tab of Hardware Setup, it sets Output 1&2 of each interface to also output to the AES [Encl] outputs. (As shown in the attachedpic) This is very useful for me.

However, if you accidentally or on purpose select one of the other outs in the dropdown for Out 1&2, it cancels this mult and you can't seem to get it back! I've tried all flavors of key modifiers while selecting, but alas, no joy.

Anybody know the secret? Is there a pref file I should delete that would get this unique out assignment back?

[29CountsNY]

If you are on a Mac, hold down Control and make the selection.
Not sure what the windows key is.

[Bentstring]

I would have sworn that I tried Ctrl and it didn't work. And perhaps it didn't. But because of your post, it does now! LOL

[29CountsNY]

HAHA, funny how that works isn't it??
I ran into the same issue awhile back and it took me forever to figure it out so I understand the frustration.