Grey Screen of Death Part 2

[hughfunkler]

So I ran the repair prebinding and it said that everything was fine. I am using ProTools 6.1 still.. stuck in the stone ages! Are OS 10.4.10 and PT 6.1 not compatible with each other? Am I stuck in a bubble in the past with this? Would it be better just to go back down to 10.2.8 where I started and scrap 10.4... Everything worked fine when I was there. Any knowledge on this will help greatly. I have 3 records that need to be finished and I have no time... AHHHHHHH!

[M.Brane]

AFAIK 10.4.10 is not yet qualified for any version of PTLE.

Tiger is a much better OS than Jaguar, but you need at least version 6.9 of PTLE.

[Slim Shady]

am using ProTools 6.1 still.. stuck in the stone ages! Are OS 10.4.10 and PT 6.1 not compatible with each other?

That is correct. 6.1 won't work with any version of 10.4 or 10.3 even. You'll need PTLE 7.x or higher, 7.1.1 or higher if you have an Intel Mac.

[Avid]

Again, click on the Compatibility link at the top of the page, then scroll down to the "Pro Tools LE Version Compatibility Grid for Mac OS X" on that page, which will take you here:
http://www.digidesign.com/index.cfm?...4&itemid=23611

Upgrade and Update information is also on that same page, below the grid.