PT-Rosetta800 setup

[Synchro1]

Hey guys,

Just got a Rosetta 800-192 to substitute a digi rack as the main A-to-D and I/O unit.

Problem:
We can't hear rec-input and playback at the same time. Any ideas?

Details:
When "source to digital out" in the Rosetta's front panel is set to "option", I can hear PT playback but no mic-input incoming signal.
When "source to digital out" is set to "analog" I can hear mic-input incoming signal, but no PT playback.

Note: we are using analog ins and digital outs
We have no other digi I/O in the system.. just the rosetta

Any help will be most appreciated.

Many thanks!

Adrián

System:

PT HD3 Accel
Rosetta 800
Mac Pro 3GHz X 2 Dual-Core Xeon

[gerax]

Hello

It's just about the same problem I had with a client of mine's system, which was AD16, DA16 and 2x Rosetta 800. All the interfaces were loaded with the X-HD expansion card, but for the life of me I wasn't able to figure out (and the manual is really useless and poorly written for such an expensive piece of gear...) how to make the Rosetta 800 work with digital I/O...I tried all of the possible combinations of the front panel buttons, but all I had with the supposedly right combination was a feedback loop... analog I/O worked fine though.

I'm sorry I couldn't help that much, but I just wanted to tell you that you're not the only one with this issue.

L.G.

[Synchro1]

Thanks for the reply, Lorenzo.

As it happens, the Rosetta can't handle internal mirroring. So you MUST pair it with something else. I ended up getting a digi 192 digital I/O to pair it with and voilà, problem solved (of course after another considerable expense)... I do believe, however, that just getting an Apogee AD16-X would do the trick on its own... Anyway, so much for that.

Thanks again, and good luck with things on your end of the world.

Adrián