No Parameter Feedback in 11.3.1

[maunaloa]

If you see blanks on the Channel Encoder Displays on an S3, make sure you haven't installed Eucon AND the Eucon control panel (in a different folder after unzipping). After I uninstalled both and reinstalled only Eucon, the Channel Encoder Displays behaved properly.

[made]

You don't experience the issues like ...

- wrong channel encoder mappings
- plugin window doesn't follow
- faders stop working
- "Save Softkeys" message on shut down
etc

on Windows?

All smooth and working?

[maunaloa]

Made, no ... not all smooth yet, but power-cycling usually fixes the weird behavior, and always fixes dead faders. I also launch Eucon manually. I have far fewer problems if I don't use third-party plugins. Kontakt 5 and Omnisphere are the worst offenders. I have had problem-free sessions after manually launching Eucon and using no third party plugins.

Here's the strangest part. The S6, S3, and Artist series all share Eucon, but each control surface has a different set of Eucon-related problems. For instance, the S3 control surface banking losing sync with the PT mix or edit window is mainly (TMK) an S3 problem. Since the S6, S3, and Artist control surfaces are different, the control surface/Eucon programming is different for each control surface, so IMO the S3 problems lie in that programming. My guess is that the assignment tables that Eucon uses are being corrupted by rogue plugins. The tables are different for each different control surfaces, so the problems are different.

See if you have fewer problems if you manually start Eucon and avoid third party plugins.

[maunaloa]

Made, see Kyle's sticky about the release of EuControl 3.2.2 and Workstation 3.2.2, and the bugs it fixes (e.g., dead faders). I've installed the updates... PT follows bank switching, and haven't had a dead fader (yet). However, the update does not fix bank following in PT11.