|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#31
|
||||
|
||||
Re: Assign Module Hardware not working
I messaged you...can you first uninstall the Master Module software and reinstall so we are starting fresh.
|
#32
|
|||
|
|||
Re: Assign Module Hardware not working
Yes, how do I do that? Sorry...
|
#33
|
||||
|
||||
Re: Assign Module Hardware not working
Settings > About > Logout. Touch Administrator. The Password = password. When you get to the desktop you can simply swipe from the right edge of the screen to the left to bring up the toolbar. Choose Settings > Control Panel > Programs and Features. Find S6 Master Module in the list and then touch Uninstall. Done.
Jeff |
#34
|
|||
|
|||
Re: Assign Module Hardware not working
Yeah I am in the same boat with three modules lit purple on a bran new out of the box system. The shift purple is lit on the fader module and the bottom left config button is lit purple on two knob modules.
I have installed a bran new current version on the MTM and these are not working even after temporarly going into "Unclaimed Mode" http://akmedia.digidesign.com/suppor...stem_88549.pdf Temporarily Unclaiming a Module If you forget to remove a module from the surface arrangement before physically moving it to another system, you can temporarily unclaim it after the new systems boots by holding the top two right-most switches on that module. However, it will reset back to its previous owner after a power cycle if not properly claimed by another system by adding it to that system’s arrangement. Unclaiming Display Modules To unclaim a Display Module: 1 Create a file named “unclaim.txt” and copy it to a FAT-formated USB flash drive. 2 Plug the USB drive into the Display Module you want to unclaim. After a few seconds, the Display Module screen displays a “Not Connected” message indicating that the process is complete. 3 Be sure to add the Display Module back to your configuration. While doing so in the Settings > Surface, Config screen, the mod- ule and/or its vacant slot might display red as if they are unavailable. This can be ignored, however, and you can drag the module back into the surface configuration to reclaim it. |
#35
|
||||
|
||||
Re: Assign Module Hardware not working
It's also a good idea to go into diagnostic mode and see if the particular module(s) are getting valid IP addresses:
Joystick Module Select + Swap (upper left) Fader Module Select + Swap (Channel 1) Process Module Clear + Func (Channel 1) Knob Module Select (Channel 1) + Select (Channel 2) Automation Module Select + Swap (Attention Track) Master Module Sel + In (next to Top Left Knob) Master Post Module Attention Switch + Link Display Module Control + Alt + Shift + V (Windows Keyboard) Jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can not assign module hardware | amolin | Avid S4/S6 | 2 | 05-06-2016 11:35 AM |
D-command main module not working | Boe Larsen | Pro Tools HDX & HD Native Systems (Mac) | 6 | 03-02-2015 09:38 AM |
Icon D-Control fader module not working | ramonpujol | ICON & C|24 | 2 | 05-17-2014 02:24 PM |
Main Module not working-Help | icenet | ICON & C|24 | 2 | 09-21-2013 01:01 PM |
hardware piano module?? | stevesound | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 4 | 03-30-2007 07:42 AM |