PT 11.2.2, Yosemite 10.10.1 - 003 rack not detected

[Rob0214]

Yeah, I know, not officially supported.

Clean install of 10.10.1, drivers for PT installed, PT installed. The 003 just doesn't show up in the list of audio drivers under system information or in the drop down list for hardware setup.

I upgraded from Snow Leopard/PT8 which works fine, so it's not a cabling issue.

Anyone else run into a similar issue? Or perhaps I'm missing something?

EDIT: Was there maybe a firmware update in between? I also tried getting the 003 into firmware update mode (mute and aux 7/8) but Pro Tools didn't offer to update.

[strangeLoop]

I am on OS X 10.10.1 with PT 11.2.2 and the 003 Rack is working OK.
I recently did the Mac software driver 003 update, but have not done a firmware update for several years.
My clean install started with PT 11.2.1.
PT 11.2.2 on Yosemite works, but not very well. The graphics are very jumpy.

[Rob0214]

Well, at least I know someone else has it kind of working.

Did you recall if you installed drivers first, then PT, or the other way around?

[Rob0214]

Ok, I'm an idiot. Didn't realize the drivers included were the HD drivers only.

And I went to avid.com/drivers, as was indicated in the little installation readme, and there were no 11 drivers.

Finally just googled 003 drivers, and it got me to the 11 drivers.

I did wind up purchasing Mountain Lion, but I don't think it was a Yosemite issue.