|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
|
#1
|
|||
|
|||
HD Omni line input gain adjustment
Hi all,
i have got my new Avid Pro Tools HD Native Thunderbolt + HD Omni and i installed it into my PC,,and it's working fine,,, but i have a question here I'm connecting my mic to my preamp (portico 5012) and its going into line input 1 of my omni interface,,,how can i control the line input 1 gain level ? my preamp gain knob is a step by step knob and i can't raise or take down a little bit of my mic gain,,,so i need to control the line input gain of my HD omni, any ideas about how to do it ??? |
#2
|
||||
|
||||
Re: HD Omni line input gain adjustment
Quote:
I think the Trim knob on your portico 5012 is for fine tuning the level. I'm guessing that is not stepped. Have you tried adjusting that? You can change the Input Reference level between +4dBu and -10dBV in the Hardware Setup -> Analog In tab inside Pro Tools. Other than that I don't think you can fine tune your line input level. |
#3
|
|||
|
|||
Re: HD Omni line input gain adjustment
yes chrisdee i tried the trim knob of my portico5012 but i still need more couple of dbs more or less than the 6dbs offered by the trim knob,
i was just searching for a fine tune solution for my mic gain without using the HD omni preamp, thanks for help bro |
#4
|
|||
|
|||
Re: HD Omni line input gain adjustment
You are connecting to the Line 1 input on the back of the Omni, correct?
__________________
X Note that all opinions, observations, whatever, in this post are mine, unless I'm being mean or am wrong, in which case it's somebody else's fault. I do not work for Avid (their loss)...my only relationship with Avid is that of a customer (when I'm not too poor to buy stuff, like now)...and that hot administrative assistant...that's more of a "thing" than a "relationship" (that should keep them guessing for a while...) Just rockin'...what more is there? Bill in Pittsburgh |
#5
|
||||
|
||||
Re: HD Omni line input gain adjustment
Quote:
Hopefully that should give you enough gain. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HD Omni Line input 2 faulty? | bloodstar57 | Pro Tools HDX & HD Native Systems (Win) | 0 | 08-24-2013 08:39 AM |
protools 10 clip gain line /volume line | alidav | Pro Tools 10 | 3 | 03-09-2013 05:21 PM |
Mbox 2 Line (TRS) Input Gain Control | taylor4814 | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 1 | 11-29-2011 09:24 AM |
MBox 3 Pro Line Input (rear) Gain | Garry R | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 0 | 08-23-2011 03:28 PM |
Analog output gain adjustment | Toney Robinson | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 2 | 08-04-2002 10:25 AM |