HP output on HDNative TB and 5.1

[Tim R.]

I can't seem to get the L-R output to go to 1-2 of my OMNI interface (and apparently therefore the Headphone output on the HD Native TB box). No matter how I adjust my output paths in the HW setup, the L-R always come out 1-3 which means the HP output on the TB box only gets Left side when using stereo. The headphone output on the OMNI gets L-R fine. Am I missing something?

[albee1952]

Hmmm, is this part of a 5.1 routing?

[TVPostSound]

Originally Posted by Tim R.

I can't seem to get the L-R output to go to 1-2 of my OMNI interface (and apparently therefore the Headphone output on the HD Native TB box). No matter how I adjust my output paths in the HW setup, the L-R always come out 1-3 which means the HP output on the TB box only gets Left side when using stereo. The headphone output on the OMNI gets L-R fine. Am I missing something?

Set up a new stereo subpath to the 5.1 bussed to output in IO, then make L&R the first 2 boxes.

[Tim R.]

Originally Posted by TVPostSound

Set up a new stereo subpath to the 5.1 bussed to output in IO, then make L&R the first 2 boxes.

As I mentioned. No matter how I route my output path (or subpaths), L-R still only come out 1-3 of the OMNI. I'll post some pictures tomorrow when I'm back in the studio.

[Tim R.]

It appears the issue is that you can't re-order the 5.1 BUS. Even though the Hardware monitor path shows L-R-C-Ls-Rs-LFE. The BUS is stuck with L-C-R-Ls-Rs-LFE. SO, even though the monitor route shows 1-2 to be LR the ACTUAL outputs are 1-3 on the OMNI.

[albee1952]

Why not feed the headphones from outputs 7&8 with a mapped send?

[TVPostSound]

Originally Posted by Tim R.

It appears the issue is that you can't re-order the 5.1 BUS. Even though the Hardware monitor path shows L-R-C-Ls-Rs-LFE. The BUS is stuck with L-C-R-Ls-Rs-LFE. SO, even though the monitor route shows 1-2 to be LR the ACTUAL outputs are 1-3 on the OMNI.

I said SUBPATH to the 5.1.

[TVPostSound]

Attached

[Tim R.]

Ah. I had done both path and subpath, but I somehow thought the bus paths needed to "line up" (pictured bellow). That was my problem. Your pictures cleared it up. Thanks TVPostSound.