96io no spdif at 96 khz issue

[carlos santana]

ok may system is
macs osx 10.4.8
Power mac G5 quad 2.5ghz
4.5GB ram
sata 160 GB system drive
sata 80 GB recording drive
firewire 400 external oxford 911 250 backup drive
protools hd accel 2 pcie 7.2cs3
96io with
avalon 2022 to analog in 1-2
dbx 386 analog in 3-4
ssl aplha logic vhd analog in 5-6-7-8

WORKING ALLWAYS AT 96KHZ

i trying to use a yamaha 01v96khz spdif out to patch all my synths into my the 96io (spdif in), the 01v96 is sync to the 96io via word clock (96io word clock out to 01v96 word clock in) when i try to record with the spdif input I GET NOTHING BUT NOISE


IVE TRIED USING THE DBX SPDIF OUT TO THE 96IO SPDIF IN WITHOUT WORD CLOCK AND IT WORKS FINE (96KHZ)

BUT I DONT UNDERSTAND WHY IT DOES NOT WORK WITH THE 01V96KHZ

i can only thing its software related i have allready been upgraded from 7.1cs10 to 7.2 cause of an issue with the adat port working at 44.1khz (it happend making punches setting an insertion point activating a preroll hitting record and when it started recording it would make all these wierd noises (freakie thing with costumers present) but the audio recorded into the trak once you stoped would play back fine....


so any help would be aprecieatted please DIGITECSOPOURT


HELP!!!!!!!!!!!!!


thanks

[DigiTechSupt]

Have you tried a different cable? What is the External Clock Output set to in HW Setups? Have you tried having Pro Tools sync to the incoming SPDIF signal from the 01V, to see if that works (without WC)?

[carlos santana]

Have you tried a different cable?

yes several

thay all work when i use the dbx spdif output into the 96 io at 96khz!!

What is the External Clock Output set to in HW Setups?

ext clock output: word clock (96khz)

Have you tried having Pro Tools sync to the incoming SPDIF signal from the 01V, to see if that works (without WC)?
yes

it dysplays 3 messeges

1- sync source is now valid

2-youre hardware does not have sync. check your sync cables or change the clock source

3-clock source source is out of range and the peripherals have been reverted to internal clock. manually reselect the desired clock source after verifying the sync source


if i try to record beforre the 2 last messeges its jus plain noise digital burst of some kind (digital errors no audio)

[carlos santana]

bump

[carlos santana]

digitechsupt


any further questions to be answerd or have you noticed anything new regarding this huge issue?

[carlos santana]

bumb

[jeff markham]

Just to be clear, you're using a 75ohm cable as the word clock source not the
S/PDIF RCA connector ... is this correct?

jeff

[carlos santana]

ok

for word clock im using a bnc cable wich i have used for lots of session at 44.1khz with spdif and adat to my interface

rca / spdif

toslink / adat

word clock / bnc

[carlos santana]

ok

for word clock im using a bnc cable wich i have used for lots of session at 44.1khz with spdif and adat to my interface

rca / spdif

toslink / adat

word clock / bnc

[mix109]

Hi Carlos

Did you try to clock the 96 from the Yamaha via word clock?
Also did you try to select Tascam SPDIF Format un the Hardware Setup?