|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
PT 8 channel vol fader
the default 0db has 12+ of gain boost and on the right side the default 0db says -6dB across from it....and it's peak is 0dB. Anyone know why those number were added on the right?
__________________
My Official Website My Official Music Forum Myspace Page Soundclick My Youtube Channel |
#2
|
|||
|
|||
Re: PT 8 channel vol fader
Because one set of numbers is for the fader and one set is for the meter.
|
#3
|
|||
|
|||
Re: PT 8 channel vol fader
I bounced a session with volume at default 0db and the meter signal levels were -6dB (that is directly across from the volume's 0dB)...maybe some peaks at -5dB. I must say, it sounded much quieter than I remember PT 7.4.
Is everyone bouncing with the master fader's vol at 0db or higher? I am not looking for a super loud mix. In fact I am comparing this sessions bounce to a "Turn it up" CD and my bounce is still quieter.
__________________
My Official Website My Official Music Forum Myspace Page Soundclick My Youtube Channel |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MC Mix/Control- Channel and fader selection | postprosound | Artist Series | 1 | 02-14-2012 09:35 PM |
Sends View Help! (w/ and w/o fader in channel) | kirkbross | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 5 | 02-22-2009 07:12 PM |
Bus Faders will not open. No Bus Fader on any channel. | SmokinBaldMonkey | Pro Tools TDM Systems (Mac) | 4 | 06-24-2008 09:57 PM |
Swapping out Channel Fader Plates | teacherman | ICON & C|24 | 5 | 02-02-2007 08:12 AM |
question about focus channel fader | tomcat | ICON & C|24 | 2 | 07-09-2006 10:19 PM |