Can't get MTRX Dante card to work...

[SomeOtherGuy]

Sorry for being dense but not sure where patch point in Dante Controller is...

[SomeOtherGuy]

Do you mean this:

[creativecontrol]

In order to route the output of your Mac applications and System Sounds to the Dante hardware input on the MTRX you need to patch your active Dante Virtual Soundcard into your MTRX using Audinate's Dante Controller software which can be found here:

https://www.audinate.com/products/so...nte-controller

Transmitters show up on the upper right - DVS (your machine name) needs to be patched to the lower left MTRX 1-2 inputs.

Jeff

[SomeOtherGuy]

Here's the Mac:

[SomeOtherGuy]

Originally Posted by creativecontrol

In order to route the output of your Mac applications and System Sounds to the Dante hardware input on the MTRX you need to patch your active Dante Virtual Soundcard into your MTRX using Audinate's Dante Controller software which can be found here:

https://www.audinate.com/products/so...nte-controller

Transmitters show up on the upper right - DVS (your machine name) needs to be patched to the lower left MTRX 1-2 inputs.

Jeff

Ah, I didn't realize I needed that. Thank you! Will download and install now...

[SomeOtherGuy]

I'm here, but not understanding transmitters show up on the upper right - DVS (your machine name) needs to be patched to the lower left MTRX 1-2 inputs.

[creativecontrol]

You need to collapse the "Gary's-Mac-Pro" under Receivers on the bottom left. You need to find your MTRX BrooklynII card which, from your other images, is currently labeled Penta-197344. Expand that and make a patch from the top - "Gary's-Mac-Pro" as a Transmitter to "Penta-197344" as a receiver for channels 1 and 2. Make sure your MTRX Dante and DVS are on the same subnet.



Jeff

[SomeOtherGuy]

Thanks, but I'm not sure where to look for Penta-197344. I don't see it anywhere in the Dante Controller panel.

Here it is collapsed:

[creativecontrol]

In the control panel for Dante Virtual Soundcard you can specify the NIC that you want the Dante streams to use. You need to correlate your Dante Virtual Sound Card NIC with the NIC that you are using for your MTRX Dante option card. That is, they both need to be on the same network. Best practices would be to have a router that supplies addresses to all devices on the network. You can check out the network settings of the MTRX including the Dante option card by going to Settings > Device List > (IP Address of unit) Right Click > Network Settings.



Jeff

[SomeOtherGuy]

I just changed the interface to en1 instead of en0 and now it shows up...