Support for mackie C4 controller

[noeqplease]

Hi,

Can we have a push to get support for this controller? It's the one that's all knobs.

It's weird to see my Mackie Control Universal being fully supported under HUI mode, but then this extender is not supported at all.

I say support it. Both the old and new versions of this unit are basically the same, internally.

Cheers

[TimNielsen]

I'm with you, but I have no faith that it will EVER happen. I was told by someone who would probably know, that Digi only continues to support HUI at all because they have some legal agreement with Mackie, and HAVE to.

They seem to have zero interest.

You could check out the Novation stuff, like the Remote Zero, they have pretty slick Automation software that can control most any plugin in ProTools.

But I agree, I'd like to see the C4 supported as well, but I sure wouldn't hold my breath over it.