Avid Pro Audio Community
How to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support
|
|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
|
|
#1
05-07-1999, 10:23 PM
|
|||
|
|||
NuBus Disk IO anomaly
Steve,
I have a Seagate 32550N (2G) and a Seagate 34573N (4G) on my NuBus PT3 TDM rig. With the 2G only all's well. With the 4G only the drive is not 'valid'. With the 4G first then the 2G, no drive is 'valid. HOWEVER, with the 2G first then the 4G, both drives mount. I'd like to retire the 2G but I can't due to this problem. Any ideas? Do I need to set the 'Motor Start Enable' or Delay Motor Start' jumpers on the 4G? Also should I set 'termination power' jumper 'to bus', 'from bus', or 'from drive'? Thanks, ripple FX
__________________
http://www.ripplefx.com Mac Pro 8 core 3.0GHz Harpertown Magma PE6R4I - HD 3 Accel +1 Process Control 24 - 96io - 1622 OSX 10.6.8 - PTHD 10.3.10 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: Nubus Disk i/o | ohm | Digidesign Hardware & Software | 0 | 03-21-2006 04:09 PM |
| Bounce To Disk Anomaly? | Steve@ZooWest | Pro Tools TDM Systems (Mac) | 3 | 04-25-2005 07:13 PM |
| PT III Disk I/O (nubus) question? | BrianPaulMichalski | Pro Tools TDM Systems (Mac) | 0 | 09-03-2003 07:47 AM |
| 882 to Disk I/O cable for Nubus | pondscum | Digidesign Hardware & Software | 2 | 06-25-2003 04:22 PM |
| NuBus Disk Problems | David Wright | Pro Tools TDM Systems (Mac) | 3 | 04-01-2001 02:55 PM |
Threaded Mode