PFL level ob the SC-48

[digilover]

Whats with that? is it me or the pal level on the concole is low?
i plug in my headset and put the level on 0 db which suppose to be loud
and when i put the AFL solo i heard it on a low volume.
and also mix to monitor is at low volume.
Whats up with that?
can i get some answers?

[rivetheadsound]

there are 2 things i can think of.
1) make sure your monitor feed knob is up if you are using the "monitor" output on the board. its the last encoder knob on the output section. it can be adjusted when the output section is set to anything other than matrix

2)might have to give the PFL solo level a boost....its in the options.

i generally have to do a bit of both of these depending on the room I'm in.

[digilover]

Originally Posted by rivetheadsound

there are 2 things i can think of.
1) make sure your monitor feed knob is up if you are using the "monitor" output on the board. its the last encoder knob on the output section. it can be adjusted when the output section is set to anything other than matrix

2)might have to give the PFL solo level a boost....its in the options.

i generally have to do a bit of both of these depending on the room I'm in.

i have tried it already
but when i put on mix to monitor mode it is very low even if it is on 0 db

[Scott Fahy]

What are you using for headphones?-- we have a pair of Sennheiser HD280's and some Sony MDR7506 and with either ones half volume is more than enough.

[digilover]

i am using the HD 25ii
but i think that the profile has a higher headphone level than the SC-48
is that true??