Clocking Issuse with 003, any ideas?

[gerax]

Hello

I recently upgraded my LE setup to a 003R (with Factory bundle). I mix OTB going out to a Dangerous 2Buss LT thru an RME AD8-AE and the 003 analog outs, printing the mox back on 2 PT tracks (which I also use ad monitor outs). I also have an Eventide Eclipse hooked up digitally to the SPdif I/O.
Since I've upgraded I've starded getting really annoying digital drops, no matter what clocking setup I use for the system: I've tried ADAT, SPdif and WC as clock suorces, I've tried to set the RME as master, Digi as master, Eclispe as master; I've also tried to clock RME and Evenetide together, but no luck, I alwys get random digital drops (and it seems they almost happen on the right channel). The system was rock solid and stable on my old 002R. PT version and plug ins remained the same, I still am on 7.4cs9.

Any ideas on what could cause that?

Thanx

[Third Eye Studios]

Hello,

Difficult to tell without knowing how the cables are hooked up. If it were me, I'd probably just use the 003R as the master, and daisy chain wordclock cables to all the other digital sevices. Then set the 003R to internal clock.

Also, double check your sample rate is the same on all units.

Also, you could decide which one you feel is the "best" clock, and go from there. Use the "best" one as the master, and daisy chain the rest with wordclock.

[gerax]

Looks like no matter what cable routing and master/slave hookup I use the problem is the same...I'm right now updating PTLE to cs10 as it seems that it fixes some strange clicks and pops that may happen...you never know...

I'll let you know how it goes...thanx for the reply.

[Third Eye Studios]

Do you experience dropouts with only the 003R connected?

[gerax]

They're not dropouts, more like loud, random clicks that mostly happen on the right channel.

My setup is
Digi 003 going ADAT > RME > analog to Dangerous 2 Bus LT
Digi analog outs > Dangerous 2 Bus LT
Digi SPdif I/O to Eventide Eclipse
Dangerous 2 Bus analog out> RME 1-2 in
RME 1-2 out ADAT > Digi 003

In PT I set up an Aux track with ADAT 1-2 as I/O which serves as my monitoring and print back of the mix.

I've tried every possible clocking and cabling setup...drive swap, cs 10 installed...FW port changed...so far nothing has worked...I'm starting to get nervous...

[Third Eye Studios]

Originally Posted by gerax

They're not dropouts, more like loud, random clicks that mostly happen on the right channel.

My setup is
Digi 003 going ADAT > RME > analog to Dangerous 2 Bus LT
Digi analog outs > Dangerous 2 Bus LT
Digi SPdif I/O to Eventide Eclipse
Dangerous 2 Bus analog out> RME 1-2 in
RME 1-2 out ADAT > Digi 003

In PT I set up an Aux track with ADAT 1-2 as I/O which serves as my monitoring and print back of the mix.

I've tried every possible clocking and cabling setup...drive swap, cs 10 installed...FW port changed...so far nothing has worked...I'm starting to get nervous...

In this configuration, what do you have your clock set to? Internal?

An additional recommendation for the future would be to try to get a hold of some wordclock cables for all of your clocking. The addition of the wordclock i/o on the 003 vs. the 002 is great.