911! Anyone know the power supply for D Command?

[amiller]

My power supply blew up this morning. Anyone know the kind used for the D Command by chance?

[mixboy bob]

Here you go!!

I have replaced 2 of mine with this. There are 3 supplies in each unit, so make sure it's the right one!

https://power.sager.com/snp-z10b-3979628.html

Good luck!

Rob Burrell
aka mixboy

[amiller]

Actually found the same thing, thanks! Turns out it was a bad chip. Overnighted a new one and BAM, back up and running as of just now!

[Will Russell]

Originally Posted by amiller

Actually found the same thing, thanks! Turns out it was a bad chip. Overnighted a new one and BAM, back up and running as of just now!

A bad chip? Where?

[Jeezer]

Always check capacitors on PSUs (virtually 'free' if you can solder) before buying whole new PSUs.

Easy to check, easy to change and in 8/10 cases it'll be a cap that's gone bad or is going bad.

[alejandro7419]

Originally Posted by mixboy bob

Here you go!!

I have replaced 2 of mine with this. There are 3 supplies in each unit, so make sure it's the right one!

https://power.sager.com/snp-z10b-3979628.html

Good luck!

Rob Burrell
aka mixboy

Hi Rob, I am about to order the same SNP-Z10B Led PSU you bought.

I did noticed that the output of the original PSU of the D-Command has 6 pins and the one you bought has 10 pins.
do you remember which pins did you have to skip when you installed them?
see picture below :

Thanks a lot

[Third Eye Studios]

Originally Posted by alejandro7419

Hi Rob, I am about to order the same SNP-Z10B Led PSU you bought.

I did noticed that the output of the original PSU of the D-Command has 6 pins and the one you bought has 10 pins.
do you remember which pins did you have to skip when you installed them?
see picture below :

Thanks a lot

Bumping this thread to see if you got your answer?? In case I need to replace mine in the future. Thanks!

[crizdee]

Originally Posted by Third Eye Studios

Bumping this thread to see if you got your answer?? In case I need to replace mine in the future. Thanks!

Hi,


SNP-Z107 Faders

SNP-Z10B Led

SNP-9544 Logic



Chris

[Third Eye Studios]

Originally Posted by crizdee

Hi,


SNP-Z107 Faders

SNP-Z10B Led

SNP-9544 Logic



Chris

Thanks for that! Do you know, are the logic and LED PSU's controlling the Xmon functions??

[elonn]

Is someone know how to open the dcommand to access to the power supply module. Is there a video somewhere in the web (I didn’t find it ).

Thanks to all member of that group.

Eric Lonni
Re recording mixer with a dcommand with the same problem as yours.