Bounce to Disk Question

[quadrivium]

Hi:

A dumb question regarding Bouncing to Disk (PTLE 7.4 003R)

I have an 8 minute session with 8 active tracks and a muted click. Whenever I try to bounce it to Disk (stereo interleaved) it will go through the bounce process and finish but the resulting file contains only a few seconds worth of audio (~116 MB)....I've tried using 'select all' and highlighting all tracks for the entire composition as well as none selected (which should use the track with the longest audible signal as the determining factor for the end)... thanks for any clues!!

[Keybeeetsss]

OK are u actually listening to the file or just looking @ the file size? thatz quite the average size...

[albee1952]

Check to make sure the Bounce source is your MAIN outputs.

[quadrivium]

Thanks Keys, Albee. It was playing through the whole thing using Analog 1 & 2 as output source (I'll check that the output is Main as suggested) , when I imported the file into another Daw It shows the initial bit of audio on both tracks followed by silence through to the end.