|
Avid Pro Audio CommunityHow to Join & Post • Community Terms of Use • Help Us Help YouKnowledge Base Search • Community Search • Learn & Support |
#1
|
|||
|
|||
Bouncing
Hello, I have a session almost done with guitar, bass and drums. In my session i also wanted to add a little kind of dubstep section. I have imported .wav sound from bank sound that i have. When i play my session in pro tools, everything is perfect just like i want but when i want to bounce my session, all is good except those sound that i have imported from my bank sound. The volume of those sound is very low. I have to increase the volume like 7db to have the result that i want after bouncing, I just dont understand why cuz when i play in session everything is just perfect.
Thanks if someone can help me. |
#2
|
|||
|
|||
Re: Bouncing
There is a lot involved here which we cannot guess.
Like what are you bouncing? The same output you are monitoring? Are you sure? How exactly are you playing back that bounce? Lots of audio players will apply EQ that may mess stuff up. Are you bouncing stereo or mono? Being careful of any phase cancellation if going mono? (But you would normally hear phasing issues not just quieter). Do you have a monitor controllers? Is that the same for both cases? How are you setting the Level bounce? Master fader? And/or compressor/limiter plugins on the master fader? A sub mix bus then going out a master fader... are you bouncing that mix bus when you mean to bounce the output? What if you set up a trivial session with say signal gen putting a 1kHz sine wave on a track and note the dBFS Level. Then bounce that, reimporting to Pro Tools or however you are playing back and measure the dBFS level and compare. |
#3
|
|||
|
|||
Re: Bouncing
I found my problem. I use bus for each part of my session exemple i send all my guitars track into the bus sGuitars and after to a drymix, the compression of my sSamples bus was way too high.
Thanks for help! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bouncing Help!!! | Fadeal | Pro Tools TDM Systems (Mac) | 3 | 03-27-2008 08:05 AM |
Bouncing in session first vs. bouncing straight to disk... | WATYF | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 5 | 11-07-2007 03:17 PM |
Bouncing down to MP3 | JOT | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Mac) | 4 | 11-18-2005 06:39 AM |
MP3 bouncing | moustaki | 003, Mbox 2, Digi 002, original Mbox, Digi 001 (Win) | 1 | 04-22-2005 06:00 AM |
Bouncing ... | Ian Fish | Pro Tools TDM Systems (Win) | 3 | 12-18-2003 07:46 AM |