2.6.2, win 7 64bit, protools hd 8.0 couldnt regonzied eucon

[dalaolv]

hi all, just switch my mc mix from G5(Leopard) to win 7 64, problems are listed:
i installed 2.6.2, upgrade the firmwire, avid icon shows on mc mix screen, connected mc mix and pc, after 30 second, mc mix was recongized by eucon, then i opened protools hd 8.0, go to setup---perperhensal---ethernet----scan----no eucon was found!!!!, tried upgraded to protools hd 8.04, same result.

after a few times restart,(i installed some software during the process) two diolog windows appeared when system start:
1.eucon network services could not be started

there was a problem with current network configuration that could not be resolved,please check your net work setting and connections and try restarting the cucontrol application, if that doesnt work, please restart your computer.

2.mc_client detected a network problem and will now exit,please check your network setting and connections

bad or null corba poa.


then i restarted the computer, same result.

equip:
euphonix mc mix I,asus motherboard p8z68-v, i3 2100, 2G kingstone ddr, 192/io,HD2 pci-x (process).

thanks a lot for concern and looking forward to answer!

[jesse p]

Upgrade to 9 or 10 if you want to use Eucon

[klaukholm]

You will have to connect via HUI mode in PT8
I strongly suggest you upgrade to v10 if you have a eucon enabled controlsurface