Errors in Slip mode for groups

[Ty Ford]

Hi,

After I group two tracks and then select them to slip, I see the selection outline around them, but when I move them only one track slips....most of the time.

I think this is a bug.

What to do?

Ty Ford

[cneal92]

This happens if the regions on the tracks do not have the same start/end time. Two options, 1) grab the longest track to trim or 2) highlight an area on all tracks at the beginning/end and delete so they all start/end at the same location. Now your trim tool will work on any of the tracks.

[dankin]

Usually when that happens its because the regions are different lengths or they have different starting points. I've seen that off and on for the as long as I've been using PT.

[Ty Ford]

and yet, this evening, while NOT trying to use groups, selecting multiple tracks and slipping worked fine.

The "known issues" in PT 10.0.1 are very for boding. They seem to outweigh the present problems in 10.0.0. Toss the code writer a few more buck to clean that mess up, will ya!

Regards,

Ty Ford