S6 assembled dimensions

[Roger Stauss]

Hi there,

If anyone owns a 4 bucket (3 fader, 1 master mod.) can you give me the dimensions of the assembled console with bolster and side covers attached?
Furniture guy needs to know...

Thanks,
Roger

[Drew Mazurek]

Originally Posted by Roger Stauss

Hi there,

If anyone owns a 4 bucket (3 fader, 1 master mod.) can you give me the dimensions of the assembled console with bolster and side covers attached?
Furniture guy needs to know...

Thanks,
Roger

Does this help?

http://www.avid.com/static/resources...moduledims.pdf

[Roger Stauss]

Hi Drew,

Thank you for the reply.

I did send this to our guy, but we're installing 4 buckets/5 knobs. He's calculating our assembly using the dimensions in your link and transposing the measurments. In the attached picture, the left corner of the side car table top wants to fit snugly to the S6 bolster. I'm hoping someone has the 4 bucket, 5 knob desk...and a ruler. I might have to write the check for the S6 a little sooner...

[Postman]

Width, 49 3/8 inches

Front to back is harder to measure exactly, requires some "eyeballing", I see it somewhere between 35 3/4 and 36 inches

Front of bolster height, 1 7/8 inches (give or take a fraction due to compression of rubber feet under frame)

Height at highest peak(not including knob and display heights, where rear covers meet module frames), 5 7/8 inches

Obviously, these are not official measurements. Depending on how you intend to mount and whether you wish to modify the way the rear plastic covers are utilized.

Check your PMs.