[bluebravo]

One other piece of info that may/may not be relevant. My outboard gear (a couple of Lexicon reverb rack units, the compeller, and an Aphex Expressor) are all connected with my system via a secondary audio interface. My primary interface is the Apollo Quad. The secondary interface - RME Fireface 800 - is connected via ADAT to Apollo. The outboard gear are connected via 1/4" patch cables to the RME. The signal flow works fine in that I am able to route any audio signal from within my protools session to any of this gear without difficulty. I have the Compellor as an insert (i/o) on the main submix bus of my mix. I hear it and see the Compellor meters jumping during playback (whether in bounce to disk mode or just simple playback). I just can't seem to get the audio signal to print during bounce.