7.4.2 and Command-8
I installed 7.4.2 on 2 computers today, both with a Command 8, and while at this point all aspects of PT seem good, when I go to enable the Command 8 in the peripheral window, PT locks up and I get the beach ball, instigating a force quit......the force quit window has the message, ProTools not responding. Now this is 2 systems, one my work studio, the other my home studio, unforgivable by the way, and quite consistent in action. Anyone see this?? Both computers are dual core 2.66 Accel 2s, etc.....10.5.3
|