[louielou]

Do you want to Slave the MPC?
or use is as the master?

In the MPC1000:
2) Go to the "MIDI/Sync" menu.
3) Set "Sync In" to the corresponding MIDI input port on the MPC.

In Pro Tools:
4) Set your tempo in Pro Tools. (See instructions at the bottom of this page.)
5) Go to the Setup menu and choose MIDI Beat Clock. Check the boxes for "Enable MIDI Beat Clock" and the corresponding MIDI output port.
6) Press play. The MPC should now be playing along with Pro Tools.
NOTE: (Make sure that the value for bars, in the MPC, is NOT set to zero. If it is set to zero, it will not be triggered.)
Setting your tempo in Pro Tools.
You can do this by either of the following methods:
1) Go to the “View” menu, highlight “Rulers” and choose “Tempo”. Click on the plus symbol (+) that appears next to where it says “Tempo” and then manually enter in the desired Tempo.
2) In the Pro Tools Transport window, de-select “Tempo Ruler Enable” (easily recognized as the blue Conductor icon) and either manually type in the desired tempo or use the tempo slider to set the desired tempo.

NOTES:
1) When using MIDI Beat Clock with Pro Tools as the master device, the MPC will be set to the tempo that you have Pro Tools set to.
2) When using MIDI Time Code (MTC), you will have to manually set the tempos in the MPC and Pro Tools to the same tempo.