View Single Post
  #21  
Old 06-02-2009, 09:02 AM
gruddlebug gruddlebug is offline
Member
 
Join Date: Jan 2007
Location: London, England
Posts: 149
Default Re: My Axiom Template for Pro Tools 8

Hello,

To Check you have the correct settings for the transport (shown below) using just the Axiom screen and buttons

Code:
Controller       CC   Ch    MSB   LSB   Pgm

LOOP             146  16    127    0    113
REW              146  16    127    0    114
FF               146  16    127    0    115
STOP             146  16    127    0    116
PLAY             146  16    127    0    117
REC              146  16    127    0    118
1. Press LOOP, wait a while and the display should say CC 146

2. Do the same for REW, FF, STOP, PLAY, and REC. All should also be CC 146

3. Press Data 1 and go through all transport controls as above, you should now see PROG 113, 114, 115, 116, 117 and 118 respectively

4. Do the same for Data 2 and they should all read MIN 00

5. Repeat for Data 3 and they should all be MAX 127

6. Finally check Chan Assign which should all be CHAN 16

If any are wrong you can easily change them from the Axiom by entering the required value on the numeric keypad while the parameter is still flashing (eg CC) on the screen

eg To set LOOP program to 113:-
Press LOOP then Data 1 then 113 - Done!

Cheers

evs
Reply With Quote