View Single Post
  #3  
Old 10-12-2008, 06:20 PM
ishur ishur is offline
Member
 
Join Date: Mar 2006
Location: Midwest
Posts: 87
Default Re: Help! D-Command not recognized

Chris:

Thanks for the quick reply. It's a first generation G5, so there's only the one ethernet port. I'm sure the port is OK, it's hooked up to a router (same one i used before I moved), along with the cable from the wall for internet, and the two cables from the D-Command. Internet works fine, which is why I don't think there's anything wrong with either the port on the Mac or the router.

The only option shown is en0, which makes sense since there's only the one port. I will try different cables but I think that it's unlikely that both ethernet cables (which worked fine before the move) would have gone bad.

I will try a different cable nonetheless, and also try a direct connection to the Mac. I don't think I've ever seen the loop cable you reference that should have come with the board.

Am I right that switching the positions of the master and fader pack shouldn't have affected anything?
Reply With Quote