Quote:
Originally Posted by JoelG
Try resetting the PMIO:
Setup Button (SETUP): Pressing the SETUP button will access additional internal parameters, such as LCD Contrast, jog wheel calibration and factory defaults. To reset the unit to factory defaults (this resets the base running mode to Cubase and resets any data that has been programmed into MIDI mode), go into the SETUP menu on the device, press the lighted SEL key under the label "Factory Defaults," then press the lighted key under the word “Yes.” There will be a slight delay (2 seconds or so) as the unit resets itself, and then it will
restart.
Joel
|
Nothing lights up when i hit the setup button, nor can i see anything on the LCD other than the squares(that i have pictured) I guess at this point im going to start tearing it apart and check all the solder points and test everything with a multimeter, something tells me a processor chip in the unit is dead, and at that point it will be garbage, sadly.