View Single Post
  #1  
Old 10-30-2011, 09:20 AM
augster augster is offline
Member
 
Join Date: Oct 2011
Location: Ohio
Posts: 7
Default MBox 3 Lights flashing

My MBox 3 was working fine. Sure, every once in a while ProTools 9 would complain that it could not find the hardware, but a simple reinstall of the MBox drivers would fix that. Recently though, when I connect the MBox, all the lights flash in sequence as though the MBox is constantly being initialized. But it is never recognized by Windows. Reinstalling the MBox drivers doesn't fix this particular issue.

Has anyone else experienced this? Any suggestions for fixing this? (Besides getting a Mac - lol)

Here is my setup:
Samsung Laptop (this laptop is dedicated for ProTools use)
Windows 7, 64 bit
Intel i3 Chipset
500GB Disk
4GB RAM
Pro Tools 9.0.5
MBox 3 (running driver v.1.0.19)
Reply With Quote