Quote:
Originally Posted by Darryl Ramm
There is one set of EUCON commands to let the surface make stuff happen in the DAW, and another set of things the DAW uses to display stuff on the surface. None of your DAW is actually running on the surface, able to just magically display stuff there. It is the DAW specifically doing stuff to get things displayed over EUCON on your surface, and that is different than just displayed on the host computer...
Sent from my iPhone using Tapatalk
|
But isn't that true across the board? In Nuage, the console surface ALWAYS matches the screen. Same goes for PT & the S6.
Isn't that just preset programming? The DAW sends specifically coded EUCON DATA to make the surface reflect whatever the DAW is doing at any given point.
As I stated earlier, if I can write a Macro that makes my 3 Artist Series units match the Visibility Agents view in Nuendo, when I launch a particular view, then that tells me that EUCON understands that command. Therefor, it COULD have been incorporated from the manufacturer. If that's not correct, then that would be what I'm trying to understand about the protocol.