[Burmansound]

Thanks for that info Manny. I discovered that the low, mid, and high band EQ controls are mapped to the ON buttons! Each press of the on buttons on pages 1 and 2 increments the control position slightly. Once you get to the end of the control's travel, the next push of the ON button positions the control at minimum, and the cycle starts all over. There is no way to decrease the value, only increase it.

Surely this is not how it's supposed to work! How do I control a knob on the EQ with a knob on the controller? The other bands work OK (the knobs on the control surface control the knobs on the EQ), just not the low, mid, and high (the 3 bands I use most!)

Thanks,

Ellis