Pb leds on d-command main units
Hi,
I use a D-command on my studio and have some troubleshouting since a short circuit has occured today.
The leds have began to flash, so I reboot the two units, then the short circuit has occured and since all the leds doesn't light anymore on the main unit but still work on the fader pack.
I've tried to adjust the brightness and the contraste but still no leds.
Reset the firmware didn't change anything.
Tried all leds test (vegas, yellow...)but no bargraph or any led's works.
However, the faders still work.
Is this a problem with the led power supplie?
How can I fix this? Do I have to change the led PSU?
How do I do that?
How much it will cost?
Thx for your answers.
Regards.
|