Pro Tools does not see my M-Audio outputs
I recently switched to Vista and installed Pro Tools. I also have a USB M-Audio Ultra.
At the back of the M-Audio, I have an Output (jack #3). routed to the input of several rack mounted effects processors that are daisy chained.
I bring the processed signal back into the M-Audio Ultra by way of Input #3 found on the back of the M-Audio.
I have recorded a vocal that sits on track 1 in Pro Tools.
I want to route that vocal track to the signal processors described above, and then have the processed signal go into my mixdown.
I am not sure how to do this. Any help would be appreciated.
The other problem, is I don't think Pro Tools can "see" all of my outputs and inputs on the m-audio.
Any advice? On the following fronts:
1. How can I tell if Pro Tools can see all of my inputs and outputs available on the M-Audio Ultra
2. If it can't, how do I make it so?
3. How do i route the track so that it gets its signal processed and then gets routed into the mix?
Thanks so much all.
Cal
|