Re: Assignable Channel Encoders 13-16 not working
Okay, after lots of searching and reading and testing, etc. I solved the problem.
The 8 encoders (4 on top and 4 on bottom of 13-16) were not sensing touch. I tested it in Utility Mode and sure enough, touch wasn't working on any of those encoders. I removed the knobs for the encoders by pulling them all up and after I did that, I discovered a little piece of something stuck wedged inbetween the silver base of the encoder and the rest of the unit on the top encoder of channel 13. I had to use a pin to get the piece out. Once I did, everything is now working as expected.
I hope this helps someone else who runs into the same issue.
|