Switching between dist and clean via footswitch
Hey all! New to the eleven rack community and eleven rack itself. I have a newb question I can't seem to find the answer to.
I found a distorted profile I like, but I can't seem to figure how to switch to a clean channel using my footswitch. It's a quarter inch jack plug.
My signal chain is as follows (I don't know if I'm doing the signal correctly, but writing it down as I understand it):
Guitar > wireless system > tuner > overdrive > guitar input on eleven rack > output to amp > orange rockerverb > :I have an effects loop here with about 6 pedals: > cabinet
I have a footswitch connected to the back of the eleven rack footswitch port. Everytime I hit the switch it goes to the next profile in line and it takes two hits for it to switch to the next one as well.
Do I need a different kind of switch, or am I doing the editor incorrectly?
Appreciate any insight! Learning a lot from this forum already. Thanks a ton!
|