Thread: Nav control -- how do I change its function?
View Single Post
  #1  
Old 03-29-2005, 02:52 PM
Brian Porick Brian Porick is offline
Member
  
Join Date: Jun 2002
Location: Wheaton, IL
Posts: 20
Default Nav control -- how do I change its function?
This has been driving me crazy for a couple of weeks, and I cannot figure it out for the life of me. When using the left and right arrows on the Control 24 under NAV, the cursor sometimes snaps to the end of a given region, and other times it goes to what ProTools perceives to be the next peak within that region. How do I change between these two settings? (Forgive me if the answer to this is really obvious; I'm overlooking it for some reason.)

Thanks so much.
Reply With Quote