Quote:
I used to do this all the time, but I haven't in a while, and now I can't seem to make it work. I want to glide automation on an aux track full of plugs to a new setting, with the sole purpose of avoiding the resonant "thunk" that sometimes happens when certain plugs (in this case, Eqium) go thorough a snapshot change. I can't seem to make it work. The automation just jumps to the new setting. Any thoughts? Did something change? I am using PT 7.3.1
thanks
|
First of all, I don't think glide works with snapshot settings in certain plug-ins . . . for instance IR reverbs.
But having said that, are you by any chance also using latch prime?
I had this problem for a while. Then I noticed that I was at the same time using latch prime.
So you do the glide, then when you hit play it replaces the glide with the latch prime setting.
If you hit undo a few times you will get back to the glide. Or what I have started to do is just click in the track to reset the cursor position thus thus removing the latch prime setting.
I hope I've expressed that right, it is a little confusing.
hth, jim