Quote:
Originally Posted by contrastestudio
Thanks a lot chris, here is where i am right now.
01.-i got the latest driver adviable in the tascam website. It says is for snow leopard witch is my OS.
02.- in the AMS is shown as an interface on his own with a firewire yellow icon, it is also shown under aggregate devices.
03.- did open pro tools holding N key and select tascam as playback engine.
04.- in the AMS the tascam is selected as input and output device, but still theres nothing coming out of my monitors...
|
Hi,
So all looks correct up to 04.
There should be a control panel for the Tascam firewire. in this control panel you can select frequency, bit rate etc and also clocking source and from memory which inputs are assigned. this control panel could be in the applications folder or utilities folder? i can't remember exactly as mine is in the dock now! but see if you have this control panel installed. and make sure all setting are matched between this and the AMS and pro tools.
the other thing is the hardware setup page in pro tools. make sure all the inputs and outputs are assigned to the appropriate analogue inputs and outputs on the tascam.
then the i/o setup page! make sure you have created inputs and output paths and they are assigned to the correct i/o on the tascam.
it should work fine. my tascam i use for mac audio but i can assign it to pro tools. it can be a bit complex having so many control panels effecting it. but it should be doable.
Chris