I am using the Behringer FCB1010 Stock (No Special PROM)
It works great but you have to do your programming on the Foot Controller.
I am in Bank Mode so I can have a Bank with 10 Presets, this is the way I prefer as opposed to Stomp Box Mode (I think it can do that too)
For Midi Patch A1 is 1, B1 is 5, etc... I have them listed in this Spreadsheet I made.
http://www.intecautomated.com/blindi...yBankv2_01.xls
The Biggest Two Procedures:
Preset Mapping - Which Program comes up when you press button.
You have to Select the Bank with the Bank Up Down and then Select a Preset 1-10 (It should be lit up)
1) Press and Hold Down Button (2.5 sec)
2) Press Up to Confirm
3) Press 1 Button (Always 1, you selected the preset prior to Holding down)
4) Press Up to Confirm
5) Enter Patch to Recall (M4 would be 52, press 5 then 2)
6) Press Up to Confirm
7) Press and Hold Down Button to Save (2.5 sec)
Footpedal Mapping - Continuous Control of Parameters
You have to Select the Bank with the Bank Up Down and then Select a Preset 1-10 (It should be lit up)
1) Press and Hold Down Button (2.5 sec)
2) Press Up to Confirm
3) Press 8 or 9 Button (8 is Left Pedal)
4) Press Up to Confirm
5) Enter CC Number (11 is MultiFX, 4 Wah, Volume 7)
6) Press Up to Confirm
7) Enter Minimum (0-127, 0 is OFF and 127 Full Volume)
8) Enter Maximum (0-127, 0 is OFF and 127 Full Volume)
9) Press and Hold Down Button to Save (2.5 sec)
You can also send a Toggle upon loading each preset.
For instance I setup a Tuner Patch on Bank 5 preset 5
1) Press and Hold Down Button (2.5 sec)
2) Press Up to Confirm
3) Press 6 Button
4) Press Up to Confirm
5) Enter CC to send (Tuner is 69, press 6 then 9) (0 to turn off)
6) Press Up to Confirm
7) Enter Minimum (0)
8) Enter Maximum (127)
9) Press and Hold Down Button to Save (2.5 sec)