Quote:
Originally Posted by adam79
Thanks, I'll try that out. Although the people at UA said that the Console software uses DSP to run.
Also, any plug-ins added in the Console app are just for recording to disk when tracking to the DAW, right?
My other question is about the +4/-10db option for the line inputs. You set this according to the cable type being used (balanced vs unbalanced), right?
Thanks,
Adam
|
My other question is about the +4/-10db option for the line inputs. You set this according to the cable type being used (balanced vs unbalanced), right?
'Fraid not...you set +4/-10 based on the levels of the equipment being connected.
While a lot of +4 gear does have balanced I/O, by no means is unbalanced I/O unusual in pro gear. And while I can't think of any names at the moment, there are a few-highly regarded equipment designers who would stuff a soldering iron some place where you really wouldn't want it to be if you tried to get them to use balanced I/O on their gear.
While I've never seen any -10 gear with balanced I/O, I assume it could be built.
So, if the connectors aren't marked on the panel, you'll need to check the manual(s)...