Strange problem using monitor outs and outs 1+2
I'm trying different patching and monitoring setups. To oversimplify the setup, I can narrow down that the problem happens when:
I connect the digi001 1+2 outs to a Berhinger 4 channel headphone amp, and then connect the 001 Monitor Outs to my powered monitors. To calibrate, I use the Signal Generator plug-in on a soloed stereo track, outputting 1kHz @ -18dBFS (my 0VU reference) to outs 1+2.
Even with all volume controls down on the 001 and the headphone amp, a not-so-quiet, very distorted signal of the 1kHz plays through my monitors.
If I pull either the digi001 1-2 or Monitor Outs, the problem goes away. If I patch the digi001 1-2 outs to various equipment other than the headphone amp, the level and amount of 1k signal I hear "bleeding" through the monitors changes. Patching the monitor outs into certain balanced equipment eliminates it completely, and it is worst with the Berhinger.
The inputs of the Berhinger Power-Play Headphone Amp are suppossed to be balanced. I am using balanced cables. Sounds to me like some kind of impedance loading deal, or some "forced feedback" type-thing.
Any electronics gurus have any ideas? I'm worried about this because I wonder how much distortion is creeping into the monitors with regular program. Hate this mystery crap...
|