[GlennR01]

1- There should be a preference to "highlight" or "lighten" visually a solo'd playlist lane, so you can easily identify the active lane without having to look at the very small left side solo button. If you have 20 playlists and they are all small, it becomes difficult to figure out which lane is the solo'd lane.

2- You have a bunch of tracks solo'd on the D-Control. You use SOLO CLEAR to clear all solos. Could you devise a way to, say, double press SOLO CLEAR to regain the exact same last solo'd track combination?. In other words, a last-solo'd-memory using the solo clear button?

3- Perhaps a preference for all meters on the meter bridge to be extinguished except for the solo'd track - it is often difficult to tell which meter corresponds to which channel, seeing as the meter bridge is unlabeled.

4- Unfortunately, there is no led scribble strip display under the individual channel meters - that would have been great, as it is difficult to distinguish which meters correspond to which channel. One solution might be a metering option that would extinguish all channel meters other than the selected channel - at least you'd know what was going on with that selected channel.

5- Any chance of altering the memory list so that there is a pointer in real time to show you where you are in your session? Perhaps "highlighting" in the softkeys area?

6- Meter Selection Preference – solo with pre-fader enables a meter solo

7- Allow SET TO DEFAULT mode to un-assign sends in the same way it removes plug-in assignments.

8- Rearrange VCA Groups on D-Control Faders - Once VCA Groups are assigned, they cannot be re-ordered on the console – is there a way to achieve this?

9- Cue Sends Metered on Master Section Meterbridge

10- Banking memory: you've banked thru your bloated track count and you hit HOME, but you want to get back to your last banking position. Perhaps you double depress the HOME button when you have the faders where you like them - this would memorize the fader position. Perhaps double pressing HOME again selects between real home and a bank position memory.

11- Currently, you cannot scroll "backwards" thru groups when displaying groups in custom faders. You can shift select beyond your first set of groups, but the only way to get back currently is by spilling the groups on to rotary encoders and touching a SEL button to get to that set of groups. There should be a more elegant way to get back to groups a - l.

15- Peak/vu combo metering would be great.

16- Cue sends are not monitorable through main monitors - I understand why. At least could there be metering for cues. One solution might be having an option under the METER button for using the main meters as cue meters.

PLUS EVERYTHING CHRIS SAID :)