Quote:
Originally Posted by albee1952
I think you should start your own thread on this issue as the OP was asking about the C24 and not the Control24. Back to the OP, with the C24, you may need a later version of Pro Tools to get the proper ethernet drivers. I suggest scouring the manual or emailing tech support to ask which versions of Pro Tools will work with the newer C24. You may also want to uninstall Pro Tools and start the install over again with the C24 attached to the computer. Watch the windows that appear during the install and see if there is a check box for installing controller drivers. Also, check thru the preferences tabs to see if your controller is available and enabled.
|
Actually the OP was referring to the Control 24... look at the date of the post.
SB