Re: First steps with MTRX Studio
Sure, that's pretty simple.
When:
I want to patch in my Distressor to use as an analog hardware insert to perform some parallel compression on a drum bus.
How:
Access Setup > IO and find the tab called H/W Insert Delay. The values are in msecs. Before you get here you are going to need to PATCH first in the Con section of DADman:
Here's an example of patching in a simple piece of analog outboard gear on channel x:
AD -> patched to DigiLink 1 on channel x
DigiLink 1 -> patched to DA for the same channel
Then find that channel number in the H/W Insert Delay window. The propagation delays are discussed in the manual - so following should work for you:
44.1 kHz = 1.29 ms
48.0 kHz = 1.17 ms
88.2 kHz = .64 ms
96 kHz = .58 ms
176.4 kHz = .28 ms
192 kHz = .25 ms
Jeff
|