When I select the output path on an audio track, I have the choice between ADAT 1-2 (stereo), 3-4 etc. OR ADAT 1 (mono), 2 (mono) etc.. This may appear slightly differently depending on how they are named in I/O setup, but the choices should be similar...
This is the same for stereo and mono tracks.. Not sure what would happen if I picked a mono output for a stereo track but maybe it would get summed?
But anyway, you should be using the mono outputs. When you do , the panner goes away. Makes sense, right? You haven't described it that way so I'm assuming you are choosing the stereo outputs... Something is not making sense, because if you are choosing the stereo pairs, then you would only be able to assign 4 unique pairs to 4 audio tracks..?? You want 8 tracks, 8 mono outputs right? Or do you have 4 stereo tracks? If so then your ADAT stereo pairs should be working as long as your stereo tracks are panned left and right...
Quote:
the stereo pairs out of the Pro Tools are somehow being summed to mono so all I see is 4 mono tracks out
|
I'm not sure you are explaining this correctly (or fully)... Only 4 analog outputs (from the fireface) are active? Where are you only "seeing" 4 mono tracks?
One way to see what the oo3 is doing with your signals BEFORE the fireface is to make 4 stereo master faders and assign them to the ADAT output pairs. If you are getting 8 discrete channels of activity on the meters, then the problem is outside of protools, maybe in the fireface...
Why are you sending these out to your mixer anyway? Are you planning on doing some analog summing? Unless you have a very nice mixer, then you probably aren't gaining very much by mixing OTB..??