View Single Post
  #3  
Old 02-17-2013, 01:44 PM
JKD99 JKD99 is offline
Member
 
Join Date: Dec 1999
Location: Los Angeles, CA USA
Posts: 1,322
Default Re: How to get of the Plosive?

I select the 'plosive, then use EQ 1-Band in AudioSuite mode with a low cut filter at around 180 or so. That will usually take care of it. Adjust the freq to taste so it gets rid of the pop and doesn't make the voice sound too then.

That said, if you're getting 'plosives recording ADR (as opposed to Narration/VO) then your actor is probably WAY too close to the mic.

Get a little distance on it and you'll not only get rid of the p-pops but it will be easier to match into production when you mix.

Best,

Joe
__________________
Joe Milner
Puget Sound, Inc.
Los Angeles

IMDB

Puget Sound on Facebook
Reply With Quote