Atmos Object Automation Phasing problems
Hi,
I have a large Dolby Atmos Mix Session here Mac PT 2020.11.
I use the Object ON/OFF Automation extensively. But If I set the automation breakpoints exactly at region in/out I hear disturbing phasing of the audio at the end.
I know it's not wise to change Object/Bus in the middle of a region - there will be a small audible silent - ok - but look at my screenshot. the breakpoint is at the end of a FADE OUT. and the whole red area is phasing.
I now try to extend these automations so no phasing is happening but that's not so nice.
any ideas?
__________________
Mac Pro 2019 16-Core, 144GB Ram, OS X 10.15
ProTools Ultimate, 2x HDX
NTP Penta720 I/O + 192 HD I/O + SSL Madi Link
Sync HD, Dolby Atmos RMU
S6 - M40 - 32channel.
Filmpost at cosmix studios vienna
http://www.cosmix.at
http://www.tom-kava.com
|