[dafatboy]

Hi,
I just upgraded to 102.
I have a problem with viewing. I hope I am not going to make this confusing.
I didn't have this issue (yesterday) with 9
The installation (upgrade) went fine, and everything opens and seems fine.
This has caught me by surprise, beacuse I have never seen this before.
I do a lot of work with 3 monitors attached.
I open PT 10.2 , enlarge the main screen across the 3 monitors.
this is about edit view size, and mix view size.
Before I could grab the left or right edge of the mix window and it would span all the way across 3 monitors. The same with the edit window
But now the maximum size they will go is limited to the monitor (1 monitor) width.
I can grab that screen and move it anywhere across the 3 monitors, but it is limited to that size.
Think of it like a plug-in opened. They are a fixed size, and you can drag them all over the 3 monitors.
The edit window can be made real small and moved all over, but they have a maximum size of the width of one of my monitor (size)
Ok,,, where is that check box at??? ha ha Thanks in advance
Bill M