Quote:
Originally Posted by mjslakeridge
From the image you attached, what I think you are looking to do is not a fade, but to lower the volume of the selection to some lower level. A fade implies going from the current volume to zero volume over some time interval. You can accomplish lowering the volume of that selection by using automation as suggested above. Set the automation to "Write" mode. Back up a few measures and hit Play. When you get close to the area you are wanting to alter, bring down the fader (easier using a control surface, but you can use a mouse). When you want to get back up to the normal volume, bring the fader back up. Then you can fine tune the automation by dragging markers around.
|
I understand that and have done it many times. I just wanted to try a fade and found out that I couldn't. Seems you should be able to do fades anywhere you want but apparently this is not so.