Re: Using a single MA703 for Monitors and other outputs.
Well, for anyone who is interested, I figured out how to do it.
1. Connect the MA703 to Madi output 1 (not 0)
2. In Patchnet, connect the Mon Output to the MA703 channels 1-8
3. Save this routing in a Patch preset.
4. In Events, create a GPIO event which recalls this preset if Alt1 or Alt2 are pressed on the console.
Save this to your defaults.
With this, the routing will be maintained no matter which CR monitor you use.
Channels 9-22 will be free to be used on your MA703.
Channels 23 and 24 should still be routed to the MC524 for solo and assigned to the Solo Bus in Patchnet.
|